GE Healthcare · MR
SecondOpinion OrthoMRI SGRA2 LNR9101815001.
Symptom
SecondOpinion OrthoMRI SGRA2 LNR9101815001 This part has been identified as one requiring second opinion approval before ordering due to one or more of the following reasons. High usage, High NDF, High cost, High demand but low consumption, difficult to isolate. See resolution concept for steps to perform before ordering this part.
Error message
OrthoMRI Incorrect gradient power supply The 5 volt enable from the thermal control ciruit has been removed.
Applies to
- Product
- OrthoMRI Escan XQ EscanXQ and EscanNE
- Software
- OrthoMRI 8.2b software Revision. OrthoMRI 8.2b software Revision.
- Component
- SecondOpinion OrthoMRI SGRA2 LNR9101815001 See comments in resolution concept for second opinion requirements before ordering this part See comments in resolution concept for second opinion requirements before ordering this part
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.