GE Healthcare · MRExciteSigna2245053
Current distortion faults with no other fault present.
Symptom
Current distortion faults with no other fault present. May happen on one, two or three gradient axes at once.
Error message
2245053 GRADIENT DRIVER TESTS - X, Y or Z Axis Fault Occurred GP Reported a X,Y or Z Axis Current Distortion Fault. Check LCoil calibration. 2245053 "GRADIENT DRIVER TESTS - %c Axis Fault Occurred.\n\ GP reported a %c Axis Current Distortion Fault.\n\ Check LCoil calibration. Swap cables between SGA\n\ & GP to isolate if SGA or GP is the source of\n\ problem.\n\ 2245053 "GRADIENT DRIVER TESTS - %c Axis Fault Occurred. GP reported a %c Axis Current Distortion Fault. Check LCoil calibration. Swap cables between SGA & GP to isolate if SGA or GP is the source of problem.
Applies to
- Models
- Excite, Signa
- Product
- Excite HDe. For Hino HDe 14.0 and HDe 15.0 Software Systems only
- Software
- HDe 14.0 For Hino Excite HDe 14.0 systems only.
- Component
- SecondOpinion: Control Board Assembly HFD-S-LITE 5138035
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.