Longitudinal Drive Calibration Does Not Converge. 3T Excite HDx 14.0.
Symptom
Longitudinal Drive Calibration Does Not Converge See Long Description The Longitudinal Drive Calibration on a new 3T HDx installation does not converge. The calculation in the procedure yields divergent results on each iteration as shown below. First it overshoots in one direction, then overshoots in the other direction on each iteration. We are using a measured distance of 1000 mm. Iteration 1 End of Travel Parameter: 2968 --> 969 mm display reading Iteration 2 End of Travel Parameter: 2472 --> 1037 mm display reading Iteration 3 End of Travel Parameter: 2472 mm --> 969 mm display reading etc. etc.
Applies to
- Models
- Excite
- Product
- 3T Excite HDx 14.0 Software. The software that this solution is tied to is indicated by the Software concept below.
- Software
- 14.0 For both Excite HDx and 3T Excite HDx systems.
- Component
- 46-282361P1 LONGITUDINAL ENCODER, MG3 A6
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.
- CWA ID100315. Auto and Manual Prescan Fails.
- Ghosted or Smeared Head Images Using Head Coil due to Head TR Assembly.
- A Copper Coolant Line or Pipe Internal to the MCS Cabinet Chiller Burst due to Water Remaining in Unit Freezing During Shipment.