GE Healthcare · MRExcite13091592
3T HDx upgrade will not pass Grafidy3 calibration.
Symptom
3T HDx upgrade will not pass Grafidy3 calibration. All coefficients in whole and zoom are in spec except for Whole Mode Long ZZ Linear Under calibration wizard ran Auto Mode twice (5 iteration each) and then tried to zero Z and run Whole Mode Gradient Z only in Auto Mode. Found no change after approximately 20+ iterations. Also swapped HFD control board from Z to Y and reran Whole Z, no change. PQR 13091592
Applies to
- Models
- Excite
- Product
- 3T Excite HDx 14.0 Software. The software that this solution is tied to is indicated by the Software concept below.
- Software
- 14.0 For both Excite HDx and 3T Excite HDx systems.
- Component
- 2331400-2 Gradient Processor GP3
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.
- CWA ID100315. Auto and Manual Prescan Fails.
- Ghosted or Smeared Head Images Using Head Coil due to Head TR Assembly.
- A Copper Coolant Line or Pipe Internal to the MCS Cabinet Chiller Burst due to Water Remaining in Unit Freezing During Shipment.