What is the Procedure to Measure Input Resistance to Z2 Coil.
Symptom
How to Measure Input Resistance to Z2 Shim Circuit and What Should the Resistances be Looking into the Z2 Output Cable FE is troubleshooting problems with the Z2 supply and/or coil and is trying to determine whether the problem is with the Z2 supply, and/or the cabling out to the magnet or the Z2 coil itself. As part of the FE's troubleshooting process, he wishes to measure the input resistance to the external circuit, i.e. the load. But there is nothing documented as to how to do this and what the resistance values should be. FE is troubleshooting problems with the Z2 supply and/or coil and is trying to determine whether the problem is with the Z2 supply, and/or the cabling out to the magnet or the Z2 coil itself. As part of the FE's troubleshooting process, he wishes to measure the input resistance to the external circuit, i.e. the load. But there is nothing documented as to how to do this and what the resistance values should be.
Applies to
- Product
- HF OpenSpeed HFO1 HFO2 and HFO3 Only.
- Software
- HFO3
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.