Advantx MPPU intermittent Error codes 42C0 (NO MA Measured) or 42B9 (Tube Select Errror, reported as possible…
Advantx MPPU intermittent Error 42B9 or 42C0 in Spot Fillm Mode
Symptom
Advantx MPPU intermittent Error codes 42C0 (NO MA Measured) or 42B9 (Tube Select Errror, reported as possible cause of NO RAD MA) in Spot Film Mode, after upgrade to Renaissance 20.4 software. Customer may report light films or blank films. The Large Spot standby current, monitored at TP18 of the MPPU Interface I Board, decreases each time the foot switch is depressed for a Fluoro exposure. When a PREP is made and the cassette returns to the park position, the Large Spot Standby filament current returns to its starting value, close to 2.50 Amps.
Error message
Error 42C0 NO MA Measured Error 42B9 Tube Select Errror, reported as possible cause of NO RAD MA
Applies to
- Models
- Advantx
- Product
- Advantx
- Component
- MPPU1 A1A1 Measures and commutation board
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh