GE Healthcare · X-ray R&FAdvantx
Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
Symptom
Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand. No exposure to the table bucky. Table grid reciprocates and the Chest stand operation is normal. Table top exposures are also normal.
Error message
Advantx Systems may report a bucky ready timeout error.
Applies to
- Models
- Advantx
- Product
- SG100 Tilting Vertical Bucky Stand Compax 40E table
- Component
- Compax 40E I/O Panel-Compatibility Board part number 45434490.
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh
- Troubleshooting an E1 Error on the Advantx ASC CPU Board