GE Healthcare · X-ray R&FAdvantx
Advantx - Ordograph in an existing room was working previously.
Advantx Ordograph Sweep won't start, no errors.
Symptom
Advantx - Ordograph in an existing room was working previously. It preps correctly and rotor starts, but the sweep won't start. Tomo Stroke signal is not being sent to the positioner RFP1A21 K108 relay contact #14. This signal is issued to the positioner by the ASC when it gets the signal from the Positioner that the Table Bucky has started its grid in motion.
Applies to
- Models
- Advantx
- Product
- Advantx
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh