Advantx 1 or Advantx E configuration unit C025 (AEC configuration) and X200 (AEC calibration) do not include i…
Advantx 1 or Advantx-E Systems AEC Calibration for FUJI CR/Filmless Service Note 3842
Symptom
Advantx 1 or Advantx E configuration unit C025 (AEC configuration) and X200 (AEC calibration) do not include instructions/procedures that support system configurations with a filmless computed radiography sub-system. Applies to Advantx Systems that are configured with a filmless computed radiography sub-system (FCR 9501, AC3, AC3-CS, AC3-CS/ID or FCR 9000). Advantx-1/Advantx-E calibration and configuration software modules do not support a filmless computed radiography sub-system.
Applies to
- Models
- Advantx
- Product
- Advantx Advantx-E
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh