GE Healthcare · X-ray R&FAdvantx
VIC - V062 Fails in Step Three
Symptom
VIC - V062 with message " brigthness signal is not between 0.1 and 2.0 volts" in step three of the calibration. FE already replaced the A15 board and also the power supply board A10. On the scope the video signal was " according " to the readback on the s V062 with message " brigthness signal is not between 0.1 and 2.0 volts" in step three of the calibration. FE already replaced the A15 board and also the power supply board A10. On the scope the video signal was " according " to the readback on the screen.
Applies to
- Models
- Advantx
- Product
- Advantx
- Component
- VIC Camera Video Image Controller
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh