Advantx - To inform field installation personel that the wire colors for MIS10247A-D are shown incorrectly in…
Advantx Wire Colors For MIS 10247B On Advantx Rad Systems Service Note 3329.
Symptom
Advantx - To inform field installation personel that the wire colors for MIS10247A-D are shown incorrectly in the MIS Chart manuals. Advantx RAD Systems must NOT follow the re-wiring diagram of connector A1 A21 A1 J102 as shown on MIS chart 10247B in Direction 46-019338 Rev.7, Advantx RAD System MIS Charts. Although the MIS charts for MIS 10247A&D (MVP & MVP Micro) and MIS 10247C (Advantx R&F) show the incorrect colors, there should be no affect since no re-wiring is performed on these systems. All the affected MIS charts will be corrected in the next revision of the MIS Chart directions.
Applies to
- Models
- Advantx
- Product
- Advantx
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh