GE Healthcare · X-ray R&FAdvantx
4721 and 4727 Camera Sweep Failure
Symptom
VIC - Errors: 4721 and 4727 Camera Sweep Failure Error 4727 and 4721 both are caused by a camera sweep failure. Determined the camera horizonal drive is missing or not satisfying the sweep fail circuit. Replaced the A12 camera sweep board, same problem. Tried a different camera head and camera cable, same problem.
Error message
Error 4721 Camera Sweep Failure Error 4727 Light Bias Error
Applies to
- Models
- Advantx
- Product
- Advantx
- Component
- VIC Camera Video Image Controller
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh