GE Healthcare · X-ray R&FAdvantx
Advantx and/or Advantx-E VIC Calibration Unit V062 Fails to Execute in Step 3 When performing VIC calibration…
Advantx and/or Advantx-E VIC Calibration Unit V062 Fails to Execute in Step 3
Symptom
Advantx and/or Advantx-E VIC Calibration Unit V062 Fails to Execute in Step 3 When performing VIC calibration unit V062, the unit fails to successfully execute step 3 and reports Brightness Signal not within .1 volts of 2.0 volts. This is confirmed by measuring the BRT signal at the ECM input test point (TP1 for ADVANTXE).
Applies to
- Models
- Advantx
- Product
- Advantx Advantx-E
- Component
- VIC Camera Video Image Controller
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh