GE Healthcare · X-ray R&FAdvantx
Advantx VIC - Setting G3 Voltage on New A9 Board When changing the VIC A9 power supply board, the label on the…
Advantx VIC - Setting G3 Voltage on New A9 Board
Symptom
Advantx VIC - Setting G3 Voltage on New A9 Board When changing the VIC A9 power supply board, the label on the back of the board can be misleading. The label on the old board, part number 46-321182G1-C states that G3 SHOULD BE SET TO 550 VOLTS FOR ALL SYSTEMS EXCEPT SYSTEMS WITH DX 1024. SET TO 700 VOLTS FOR DX 1024. The label on the new board, part number 46-321182G2-D states that G3 SHOULD BE SET TO 550 VOLTS FOR ALL SYSTEMS.
Applies to
- Models
- Advantx
- Product
- Advantx
- Component
- VIC Camera Video Image Controller
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh