GE Healthcare · X-ray R&FAdvantx
Advantx VIC - Unable to adjust beam current (cal unit V053).
Symptom
Advantx VIC - Unable to adjust beam current (cal unit V053). Error: 8751 When trying to set the maximum beam current, the FE increases the light source to the PUT target up to 2000 nA (2000 mv as measured between TP1 and TP2 of VIC1 A15 board). The reading on the Advantx console only goes up to 400 nA and then starts to drop. Video readback calibrates o.k. Ran SLD's for the VIC1A15 bd. (where the readback logic lives) and VIC1 A9 boards and failed test 8751 (Camera i/f bd. status port test) passing all the others.
Error message
8751 Diagnostic error: Iris amplifier test
Applies to
- Models
- Advantx
- Product
- Advantx
- Component
- VIC Camera Video Image Controller
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh