GE Healthcare · X-ray R&FAdvantx
VIC Camera Head H-Sweep Board - Sweep size and center off.
Symptom
VIC Camera Head H-Sweep Board - Sweep size and center off. Diagnostic Error Code: 8762 Horizontal size and center were both properly in adjustment on 8/1/97. Currently the image is approximately twice the correct size and shifted to the right by about 50% as viewed on the monitor. FE was able to adjust the conventional image back into spec but he was at one limit of the adjustment. The digital images are so far out that they cannot be adjusted.
Error message
Error 8762 Error 8762
Applies to
- Models
- Advantx
- Product
- Advantx
- Component
- VIC Camera Video Image Controller
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh