GE Healthcare · MR
The adsorber is saturated.
Symptom
Magnet Shield Cooler:Coldhead temperature still remains, just out of spec after coldhead change and compressor pressure is ok
Applies to
- Product
- Magnet LCC. Software Version Concept should NOT be selected for Magnet Products Serial #: 1.5T (Rxxx) / 1.0T (Qxxx) He Vessel Pressure:>3 psig but <5 psig Shield Temp:< 55 K Coldhead Temp:> 3.8K but < 4.5K Recondenser Temp:> 4.2K but < 4.55K Delta Temp (Coldhead - Recondensor):> 0 but < 0.3K Min. LHe Fill Level: 50% Min. LHe Ramp Level: 90% Min. LHe Shim Level: 75% Helium Volume:1940 L (1.5T) Helium Volume:1970 L (1.0T) Burst Disk <":2319285 Burst Disk >":2350415 Burst Disk O-ring:46-281101P1 Baffle Assy 2180818 Low Cryogen Consumption
- Component
- 2172241 Adsorber for Sumitomo Compressor models CSW 71D and CSA 71D. 2172241 Adsorber for Sumitomo Compressor models CSW 71D and CSA 71D. The basic maintenance work is to replace the oil mist Adsorber of the Compressor Unit for every 20,000 Hrs of operation. 2172241 Adsorber for Sumitomo Compressor models CSW 71D and CSA 71D. The basic maintenance work is to replace the oil mist Adsorber of the Compressor Unit for every 20,000 Hrs of operation
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.