System Does Not Recognize the 0.7T Wrist Array Coil.
Symptom
System Does Not Recognize the 0.7T Wrist Array Coil See Long Description When the tech plugs in the coil from either side of the table, the system doesn't recognize it. It logs error code 2258106 which is "Coil ID not found in CoilConfig.cfg file. Connector: Right Port Coil ID: MRIDWRIST0.7T" If they plug it into the left side of the table they get the same error message for the "Left Port". In checking the coil service manual and the /w/config/CoilConfig.cfg.0.7T template file, we can see that this coil's coil ID should be "MRIDWRIST". This is the first time they've tried to use this coil, and all other coils are working. We suspect the Coil ID chip for this coil is coded incorrectly. The FE has replaced the coil's cable, but this didn't help. Error logged with coil in Left Port: 2258106 GEopen01 coilCK coilCK_scp.c 940 Host coil validation error: Coil ID not found in CoilConfig.cfg file. Connector: Left Port Coil ID: MRIDWRIST0.7T. Error logged with coil in Right Port: 2258106 GEopen01 coilCK coilCK_scp.c 940 Host coil validation error: Coil ID not found in CoilConfig.cfg file. Connector: Right Port Coil ID: MRIDWRIST0.7T.
Error message
2258106 Host coil validation error. Coil ID not found in coilconfig.cfg
Applies to
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR5-HFO5 Open Speed with Excite Product
- Component
- 2279915-2 0.7T Wrist Array Coil
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Unable to run Auto Grafidy.
- Can't find the coil configuration for the M3335LJ 1.5T HD 8Channel Wrist Array Coil made by Invivo.
- CoilID Validation Fails Due to Wrong Coil Connector
- Sentinelle table support group must be contacted to install the table configuration.
- unable to auto configure a new Coil Due to Coil Can Not Be Auto Configured Because it is Not Compatible With Upgrade HDxT, Only Forward Production HDxT.
- Lower Legacy port Coil ID fails due to bent pin 7 on J20 connector of SRI.