GE Healthcare · X-ray R&FAdvantx
ADXE Legacy no exposure to Wall Stand
Symptom
ADXE Legacy no exposure to Wall Stand The system makes an exposure to the Wall Stand if the XRT is rotated 180 degrees opposite of the actual Wall Stand position. The Wall Stand is at the foot end of the table, but the system thinks the Wall Stand is at the head end.
Applies to
- Models
- Advantx
- Product
- Advantx-E Legacy Advantx-E
- Component
- Legacy Table
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh