Top Coil Port Always Indicates a Coil Even When Not in Use.
Excite 11.0. shorted wire in data cable which runs from Multi-coil preamp assembly down to 8 channel switch
Symptom
Top Coil Port Always Indicates a Coil Even When Not in Use. System always recognizes a coil as being present in the top connector regardless of whether any coil was plugged in or not. Coil ID indicator would not switch to green (coil identified). Diags would show coil present, but toggle between correct ID and coil not identified. Could not scan multi-coil at all because system detected multiple coils connected at once. If cable between 8 channel switch and MC preamp assembly was disconnected at MC preamp assembly, there was no change in LED. If cable was disconnected at the 8 channel switch end, LED went out.
Error message
Coil ID LED always lit yellow.
Applies to
- Models
- Excite
- Product
- Excite Includes Excite 1 and Excite 2, 10.0, 11.0 and 11.1 Software.
- Software
- 11.0 Only for 1.5T Excite product. 12.0 is Excite HD and 14.0 is Excite HDx. Note, 3T Excite goes with software G3, not 11.0 or 11.1.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.
- CWA ID100315. Auto and Manual Prescan Fails.
- Ghosted or Smeared Head Images Using Head Coil due to Head TR Assembly.
- A Copper Coolant Line or Pipe Internal to the MCS Cabinet Chiller Burst due to Water Remaining in Unit Freezing During Shipment.