GE Healthcare · MR
MM3 does not display Helium Level in Analog data
Symptom
Magnet Monitor 3 does not display Helium Level in Analog data. Log into the device using web mode, then choose "view Analog data". It shows "zero" (0) for He level (even after reading a new sample). Read it on the Mag Mon panel under Data, you will have the right reading. The other readings are all displayed in the "view Analog data".
Applies to
- Product
- Magnet Monitor 3. Magnet Monitor 3 Magnet Monitor 3
- Software
- Magnet Monitor 3 revision 1.52 Magnet Monitor 3 revision 1.52, see the long description for the list of major changes associated to this software version. Here is a list of the major changes associated with the 1.52 MM3 release. Rev 1.52 MM3 not uploading the gateway value to the back office MM3 not uploading the Heater_on_limit to the back office. MM3 not uploading its case temperature to the back office.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.