GE Healthcare · X-ray R&FAdvantx
DRS 2.2 Communication Error with Sterling/Dupont Linx Laser Camera
Symptom
Applies to Advantx drs 2.2 (drs cpu firmware version 3.32). When operator attempts to film an image, the DRS sends a RRQS (request for status) command to the laser camera, but the camera requires an RQS. This causes the camera to send a Syntax Error to the DRS and an error message is displayed on the DRS monitor. DRS 2.2 doesn't communicate properly with the Sterling Dupont Linx Laser Camera.
Applies to
- Models
- Advantx
- Product
- DRS
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh