GE Healthcare · X-ray R&FAdvantx
Ultranet Auto Collimation not working properly
Symptom
Ultranet Auto Collimation not working properly Not getting Auto Collimation to Table Bucky when the table is horizontal. Auto collimation works when the table is vertical, and it also works to the chest stand. A backup database was reloaded. The Sid Pot feedback to the collimator board was checked. Checked that the collimator mercury switches were working and that the bucky was sending back the cassette size and cassette in place signals properly.
Applies to
- Models
- Advantx
- Component
- Collimator Ultranet
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh