"Y-Axis Overtemperature Fault" Scanning FIESTA-C Protocol, Scan Aborts, due to HFA Control Board
Symptom
"Y-Axis Overtemperature Fault" Scanning FIESTA-C Protocol, Scan Aborts Unable to complete a FIESTA-C scan. Sequence>TE=minimum, Flip Angle=75, Band Width=62.5, Freq Matrix=384, Phase Matrix=256, NEX=2 FOV=20, SliceThickness=1, Locs per Slab=32 The scan aborted with error code 2244579 "The GP is reporting a Y Axis OverTemperature Fault. System will wait 5 minutes before attempting recovery.->. Changed Rx to FIESTA by copying FIESTA-C sequence (except for NEX so as to maintain the same scan time) and had no problem. The problem only occurs with FIESTA-C Unable to complete a FIESTA-C scan. Sequence>TE=minimum, Flip Angle=75, Band Width=62.5, Freq Matrix=384, Phase Matrix=256, NEX=2 FOV=20, SliceThickness=1, Locs per Slab=32 The scan aborted with error code 2244579 "The GP is reporting a Y Axis OverTemperature Fault. System will wait 5 minutes before attempting recovery.->. Changed Rx to FIESTA by copying FIESTA-C sequence (except for NEX so as to maintain the same scan time) and had no problem. The problem only occurs with FIESTA-C
Error message
2244579 The GP is reporting a %x Axis OverTemperature Fault. System will wait 5 minutes before attempting recovery 2244579 The GP is reporting a %x Axis OverTemperature Fault. System will wait 5 minutes before attempting recovery.->
Applies to
- Models
- Excite, Signa
- Product
- Excite HD For 12.0 1.5T Systems only.
- Software
- 12.0 Excite HD and 3T Excite HD products only
- Component
- 2396050-2 HFA CONTROL BOARD ASSEMBLY
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.