GE Healthcare · MRExcite2252303
Unable to Scan With Multi Coil Bias Faults
Symptom
Unable to Scan With Multi Coil Bias Faults Unable to scan with Multi Coil Bias Faults
Error message
2252303 Multicoil Bias Fault Detected, Short Circuit. Channel X of Y See Long Description Error: 2252303 Host: lx-mr Process: NSP File: SCP:DCB Line: 1030 Multicoil Bias Fault Detected - Short Circuit. Try re-seating all coil connectors. MCD1 Channel 3 of 16, counting from 1 Value: -310 mA Limit: -301 mA Mask of failed channels: 0x3c Ch 1-8 : Legacy MC Conn Ch 17-24 : Conn A Ch 25-32 : Conn B-> Extended Error: This fault was detected by the Driver Module. A short circuit fault occurs when the actual value is more negative than the pre-defined limit. This could be caused by a shorted diode in the coil or a short elsewhere in the system. Check coil, system cables, connectors and configurations. The mask of all failed channels indicates additional channels with the same fault - convert the hex number to a bitmap to decipher the mask, with channel 1 indicated by the least significant bit and channel 16 indicated by the most significant bit. For example, a mask of 0x3c converts to 0011 1100, meaning channels 3, 4, 5, and 6 all experienced the same failure. The key at the bottom of the error message shows the MC driver bias channels provided by the Driver Module used with each multicoil
Applies to
- Models
- Excite
- Product
- Excite HD For 12.0 1.5T Systems only.
- Software
- 12.0 Excite HD and 3T Excite HD products only
- Component
- 2414066 "Right Leg Assembly" (of the M3087JH USAI "1.5T HD Lower Leg Array Coil") Part description is "FRU RIGHT LEG ASSY W/O CABLE 3RD STA"
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.
- CWA ID100315. Auto and Manual Prescan Fails.
- Ghosted or Smeared Head Images Using Head Coil due to Head TR Assembly.
- A Copper Coolant Line or Pipe Internal to the MCS Cabinet Chiller Burst due to Water Remaining in Unit Freezing During Shipment.