How many PIM modules are required for the ReFlex400B AP option?
Symptom
How many PIM Modules are Required for the ReFlex400B AP Option? FE has only one PIM module to use when installing the ReFlex400B AP option, but the install doucument specifies that two be installed. See Long Description for details. The FE was installing the Reflex 400B AP option in this Excite II system running 11.0 M4 software. In Direction 2333500-1, Rev# 7.0 "Signa EXCITE 1.5T Service Methods", document 2376837 "ReFlex AP Option Installation for EXCITE II", section 4.6 "Installation of PIM modules" at step 2 we find this statement: "Install 2 PIM modules onto the SC backplane between slots 2 and 3. See Illustration 5 and Illustration 6. The PIM modules allow communication between the Master and Slave boards." But the FE was provided with only one PIM module, and the illustrations show only one PIM module installed. Is this a mistake?
Applies to
- Models
- Excite, Signa
- Product
- Excite Includes Excite 1 and Excite 2, 10.0, 11.0 and 11.1 Software.
- Software
- 11.0 Only for 1.5T Excite product. 12.0 is Excite HD and 14.0 is Excite HDx. Note, 3T Excite goes with software G3, not 11.0 or 11.1.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.