AirSys chiller, M3088TL, must be properly adjusted for pressure output.
Symptom
AirSys chiller, M3088TL, must be properly adjusted for pressure output. SMILe 3/24/04 Effectivity: Sites installing the new AirSys Chillers (M3088TL) or Heat Exchanger (M3088TK). These units are replacing the Ellis & Watts chillers, used on TwinSpeed systems. Ellis & Watts will continue to supply chillers for the HFO system. Note, Ellis & Watts will be the service provider for AirSys Chillers (M3088TL) in Europe and America's pole. AirSys will be the service provider for the Chiller (M3088TL) in all of Asia.The Heat Exchanger (M3088TK) will be serviced by GE SMILe 3/24/04 Effectivity: Sites installing the new AirSys Chillers (M3088TL) or Heat Exchanger (M3088TK). These units are replacing the Ellis & Watts chillers, used on TwinSpeed systems. Ellis & Watts will continue to supply chillers for the HFO system. Note, Ellis & Watts will be the service provider for AirSys Chillers (M3088TL) in Europe and America's pole. AirSys will be the service provider for the Chiller (M3088TL) in all of Asia.The Heat Exchanger (M3088TK) will be serviced by GE.
Applies to
- Product
- Airsys Medicool Chillers
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.