Unable to scan due to TPS IPG Initailization errors on profile3.
Symptom
Unable to scan due to TPS IPG Initailization failure. RX_LO LED not lit on CERD. CERD diagnostics fail to run. System will not scan due to TPS/IPG Initialization errors and runs very slow. Apps software boots. IPG comes all the way up. EX_LO on CERD lit. RX_LO is not lit. Emulating CPB makes system run at normal speed but TPS still fails to initialize. No VME Access led on IPG (should intermittantly flash). VME BIT3 (192.0.0.2) dropping 8-15% of bits with ping -s command. SBUS BIT3 (192.0.0.1) doesn't drop any bits. IPG diags pass, CERD and SBAM diags do not.
Applies to
- Product
- Profile 3 Ultrasparc CPU with AN8290Y gradients
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.