Gradcal will not converge.
Symptom
Gradcal will not converge. Applying recommended corrections causes major changes in calibration results FE is running Gradcal on a new installation. He's using the Automated Gradcal Tool from the Service Desktop, but the same thing happens in manual mode also. The phantom measurements are fairly close to nominal, but they are out of spec and need touching up. The program applies corrections to the xfull, yfull, and zfull values that are too large, causing swings that are too far into the wrong direction. The FE checked the phantom position in all three planes and found it to be correct.
Applies to
- Models
- Excite
- Product
- Excite HD For 12.0 1.5T Systems only.
- Software
- 12.0 Excite HD and 3T Excite HD products only
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.
- CWA ID100315. Auto and Manual Prescan Fails.
- Ghosted or Smeared Head Images Using Head Coil due to Head TR Assembly.
- A Copper Coolant Line or Pipe Internal to the MCS Cabinet Chiller Burst due to Water Remaining in Unit Freezing During Shipment.