GE Healthcare · MRExcite2266420

HDE System Emergency Stop EMO Trips Immediately after Reset.

Symptom

HDE System Emergency Stop EMO Trips Immediately after Reset When the EMO RESET is pressed, you can hear the contactor "connected or closing" sound in PDU, but it will disconnect immediately by itself. The main breaker was not tripped. The EMO Reset will not stay latched. Also a message; PDU is in stop mode,24V power is only 20.3V in the cabinet monitor appeared in the status window located in the upper left corner window. When the EMO RESET is pressed, you can hear the contactor "connected or closing" sound in PDU, but it will disconnect immediately by itself. The main breaker was not tripped. The EMO Reset will not stay latched. Also a message; PDU is in stop mode,24V power is only 20.3V in the cabinet monitor appeared in the status window located in the upper left corner window.

Error message

2266420 Cabinet Monitor:A water flow failure was detected on the cabinet cooling system. Error: 2266420 Host: GE_MR2 Process: NSP File: SCP:CabMonHWO Process: NSP File: SCP:CabMonHWO Line: 569 Exception Class: Unknown Severity: Unknown Function: Power/Support Systems: Environmental Sensors/Controls PSD: FSE-XL Coil: 8CTL456 Scan: 841/6 Cabinet Monitor:A water flow failure was detected on the cabinet cooling system. The system goes to Emergency Stop State. Please contact your Service Representative and check cooling system with them.

Applies to

Models
Excite
Product
Excite HDe. For Hino HDe 14.0 and HDe 15.0 Software Systems only
Software
HDe 15.0 For Hino Excite HDe 15.0 systems only.
Area
MR

Full cause & step-by-step resolution

The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.

Start free trialSign in

7-day free trial · no credit card required

Related GE Healthcare MR issues