GE Healthcare · X-ray VascularAdvantxInnova
No exposure, maximum tube housing heat units reached Allow time to cool
Symptom
No exposure, maximum tube housing heat units reached Allow time to cool no exposure, maximum tube housing heat units reached Allow time to cool
Error message
42C5 No Exposure; Maximum Tube Housing Heat Units Reached. Allow time to cool is displayed on the Advantx console
Applies to
- Models
- Advantx, Innova
- Product
- Advantx E Biplane Advantx E biplane systems: LCLP+ (22 cm II), LCN+ (32 cm II), LCALP+ (40 cm frontal plane, 32 cm lateral plane) Advantx E biplane systems: LCLP+ (22 cm II), LCN+ (32 cm II), LCALP+ (40 cm frontal plane, 32 cm lateral plane) Innova 2000 Innova 2000 systems Innova 2000 systems Advantx E Monoplane Advantx E Systems advantx e, vamp Advantx E generator Systems
- Component
- Advantx-E VAMP Advantx-E VAMP Advantx-E VAMP
- Area
- X-ray Vascular
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare X-ray Vascular issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray Vascular issues
- The Worklist does not refresh on the system when performing a query.
- Innova System boot failure
- INX1X; Message Limit switch engaged; LP4 Lateral Detector lift will not move after going to max SID using the Emergency Backout button on the lift cover because the lift hit maximum (Max) SID limit sw…
- Firewall is broadcasting DHCP addresses
- Cooling Failure; Shut System down and call Service is displayed on the Innova Image monitor
- No gantry motion is reported by the customer.