GE Healthcare · MR

Magnet Monitor 3 was not placed into Service Mode prior to Magnet or System Service.LCC_HMI2 ALARM I2 - CH RUO CBL OPEN.…

Magnet Monitor 3 was not placed into Service Mode prior to Magnet or System Service.LCC_HMI2 ALARM I2 - CH RUO CBL OPEN.Use Magnet Monitor 3 Service Mode When Performing Magnet Service or System Servi…

Symptom

LCC_HMI2 ALARM I2 - CH RUO CBL OPEN LCC_HMI2 ALARM I2 - CH RUO CBL OPEN, the coldhead RUO cable has been disconnected or is damaged in a way that the Magnet Monitor 3 would be able to detect an open circuit.

Error message

LCC_HMI2 ALARM I2 - CH RUO CBL OPEN LCC_HMI2 ALARM I2 - CH RUO CBL OPEN, the coldhead RUO cable has been disconnected or is damaged in a way that the Magnet Monitor 3 would be able to detect an open circuit.

Applies to

Product
Magnet Monitor 3. Magnet Monitor 3 Magnet Monitor 3
Software
Magnet Monitor 3 Revision 1.62 Magnet Monitor 3 Revision 1.62. Magmon3 Software has been updated to Revision 1.62 to support new magnet model type LCC-RB 1.5T. See Attached Service Note DOC0689332 and Long Description for more details. This software revision is also compatible with all installed base GE magnets (S2 through S5, SX, CX, LCC, LCC300 & 7.0T). The part number and revision of Magmon3 (P/N 2394952) is not changing. Refer to the latest version of Service Note DOC0689332 at http://3.87.118.28/optec3/common/fmisn/sn.htm
Area
MR

Full cause & step-by-step resolution

The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.

Start free trialSign in

7-day free trial · no credit card required

Related GE Healthcare MR issues