GE Healthcare · MR
Magnet Monitor 3 improperly configured.SIIII2 ALARM I2 WATERFLOW LIMIT.Configure Magnet Monitor alarm setpoints per late…
Magnet Monitor 3 improperly configured.SIIII2 ALARM I2 WATERFLOW LIMIT.Configure Magnet Monitor alarm setpoints per latest SOP-wqr.Magnet Monitor 3 1.62
Symptom
SIIII2 ALARM I2 WATERFLOW LIMIT SIIII2 ALARM I2 WATERFLOW LIMIT, the Water Flow is higher than the High Alarm Limit setting for the Magnet Monitor 3.
Error message
SIIII2 ALARM I2 WATERFLOW LIMIT SIIII2 ALARM I2 WATERFLOW LIMIT, the Water Flow is higher than the High Alarm Limit setting for the Magnet Monitor 3.
Applies to
- Product
- Magnet Monitor 3. Magnet Monitor 3 Magnet Monitor 3
- Software
- Magnet Monitor 3 Revision 1.62 Magnet Monitor 3 Revision 1.62. Magmon3 Software has been updated to Revision 1.62 to support new magnet model type LCC-RB 1.5T. See Attached Service Note DOC0689332 and Long Description for more details. This software revision is also compatible with all installed base GE magnets (S2 through S5, SX, CX, LCC, LCC300 & 7.0T). The part number and revision of Magmon3 (P/N 2394952) is not changing. Refer to the latest version of Service Note DOC0689332 at http://3.87.118.28/optec3/common/fmisn/sn.htm
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.