GE Healthcare · MRExciteSigna22460272265062
Cannot scan with DCERD errors.
Symptom
Cannot scan with DCERD errors
Error message
2246027 The diagnostic platform was accessed with an invalid parameter 2265062 DCERD Fiber Optic Link Error on the Master DCERD Digital board. Rx Signal Detect signal is in an Invalid State. Extended Error: Check the Gigalink fiber optic connection between the IRF I/O and DCERD Digital Boards. If fiber cables are connected and the system indicates that the DSP bit0 LED isn't blinking then check the state of the power status LEDS on the front of the Digital Board. If any are not illuminated then check for missing voltages from the test points on the front of the DCERD power supply modules. Possible cause(s): IRF Board, IRF I/O Board, DCERD Digital board.
Applies to
- Models
- Excite, Signa
- Product
- Excite HDe. For Hino HDe 14.0 and HDe 15.0 Software Systems only
- Software
- HDe 15.0 For Hino Excite HDe 15.0 systems only.
- Component
- 5141010 Power Supply for ASC and DCERD
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.
- AE title has changed on destination host.
- Unable to Load Applications Software during restoreinfo Due to Corrupt saveinfo Disk.