GE Healthcare · MR
Magnet Monitor 3 was not placed into Service Mode prior to Magnet or System Service.lcc_hmi2 alarm I2 HePressure Low.Con…
Magnet Monitor 3 was not placed into Service Mode prior to Magnet or System Service.lcc_hmi2 alarm I2 HePressure Low.Contact FE that performed magnet service to determine appropriate action.wqr.Magnet…
Symptom
lcc_hmi2 alarm I2 HePressure Low lcc_hmi2 alarm I2 HePressure Low, the Helium Vessel Pressure is lower than the low limit alarm settings on the Magnet Monitor 3.
Error message
lcc_hmi2 alarm I2 HePressure Low lcc_hmi2 alarm I2 HePressure Low, the Helium Vessel Pressure is lower than the low limit alarm settings on the Magnet Monitor 3.
Applies to
- Product
- Magnet Monitor 3. Magnet Monitor 3 Magnet Monitor 3
- Software
- Magnet Monitor 3 Revision 1.62 Magnet Monitor 3 Revision 1.62. Magmon3 Software has been updated to Revision 1.62 to support new magnet model type LCC-RB 1.5T. See Attached Service Note DOC0689332 and Long Description for more details. This software revision is also compatible with all installed base GE magnets (S2 through S5, SX, CX, LCC, LCC300 & 7.0T). The part number and revision of Magmon3 (P/N 2394952) is not changing. Refer to the latest version of Service Note DOC0689332 at http://3.87.118.28/optec3/common/fmisn/sn.htm
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.