GE Healthcare · MR
OrthoMRI System won't boot getting DSP error number 40
Symptom
OrthoMRI System won't boot getting DSP error number 40
Error message
OrthoMRI Error opening DSP (error number 40) ESAOTE suggestions: Try to perform these steps in this order: re-boot the system and check the DSP initialization, change the DSP board, reload software. Note: The manufacturer does not include checking the PC power supply as a troubleshooting step. This should be the first step. Then, if all voltages are in specification, proceed with the manufacturer's suggestions.
Applies to
- Product
- Orthopedics E-Scan (Win) XQ. Orthopedics E-Scan (Win) XQ.
- Software
- OrthoMRI S/W Release 9.1B. OrthoMRI S/W Release 9.1B.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.