GE Healthcare · MR
OrthoMRI Incorrect jumper settings on the RFM which is used on CscanNE and EscanNE MRI systems.
Symptom
OrthoMRI Getting error message with new RFM module OrthoMRI Getting error message with new RFM module.
Error message
OrthoMRI 1-3-156 Hardware error See Long Description 1-3-156 Hardware error Try to perform these steps in this order: re-boot the system and repeat the Command/Operation that went wrong, check the functionality of the module indicated in the error message – RFM failure: perform the homogeneity test and check the receiving channel, check the system functionality and system connections, try to replace the module
Applies to
- Product
- OrthoMRI CscanNE. OrthoMRI CscanNE.
- Software
- OrthoMRI S/W Release 9.1B. OrthoMRI S/W Release 9.1B.
- Component
- OrthoMRI LNR9102496000 RFM Module OrthoMRI LNR9102496000 RFM Module
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.