Fluoro Taper calibration cannot be submitted in the SUIF

Pre-Unity systems: Fluoro Taper calibration cannot be submitted in the SUIF Pre-Unity systems: During Fluoro Taper calibration, the measured values are too low / too high, and cannot be submitted in the SUIF. See long description for further details. Pre-Unity systems: During Fluoro Taper calibration, the measured values are too low / too high, and cannot be submitted in the SUIF. In the SUIF, there is an acceptance range defined on the input values (5-20 R/min, in “5R” countries, 2.5-10 R/min), and the values outside this range are rejected, i.e. after writing them in the SUIF, the user cannot go to the next calibration step. Also, there is an acceptance range defined on the Calibration values, and if the inputs’ extreme value result in an out-of-range calibration value, the calibration cannot be submitted. There is no direct correspondence between the Calibration value acceptance range, and the range of acceptable doses (dependant on system performance), but typically, values outside the range 6-16 R/min (in “5R” countries, 3-8 R/min) are rejected.