GE Healthcare · MR
OrthoMRI New coil was not tuned to the system's center frequency
Symptom
OrthoMRI New coil won't scout getting an invalid error
Error message
OrthoMRI Invalid configuration parameter See Long Description NOTE Always use the most current revision of service documentation! ESAOTE's suggestions for this error Try to perform these steps in this order: follow the SW suggestions if present into the shown message,check the Phantom position and Coil connection, re-boot the system try to repeat the Calibration that went wrong, check the System functionality (e.g.: perform the System Check), reload the software
Applies to
- Product
- OrthoMRI EscanNE. OrthoMRI EscanNE.
- Software
- OrthoMRI S/W Release 9.1B. OrthoMRI S/W Release 9.1B.
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.