GE Healthcare · X-ray VascularInnova1050015
The Gantry Pivot position does not match the In Room Display.
Symptom
The Gantry Pivot position does not match the In Room Display. When the Gantry is driven the Angle changes, but when the Gantry displays reads 0 the gantry angle indicated by the IRD is a value other than Zero. The Gantry Pivot position does not match the In Room Display. When the Gantry is driven the Angle changes, but when the Gantry displays reads 0 the gantry angle indicated by the IRD is a value other than Zero.
Error message
1050015 C-arc AXIS POT ENCODER MISMATCH DO GantryAxis Intermittent Motion stop C-arc AXIS POT ENCODER MISMATCH 1 0 - potentiometerEncoderMismatch Z:/heroic/motion control task.c 4560 1050015 C-arc AXIS POT ENCODER MISMATCH DO GantryAxis Intermittent Motion stop C-arc AXIS POT ENCODER MISMATCH 1 0 - potentiometerEncoderMismatch Z:/heroic/motion control task.c 4560
Applies to
- Models
- Innova
- Product
- Innova X1 X1 Biplane Innova X1 X1 Bi-plane Innova 2121 or 3131 Bi-plane System Innova X1 X1 Bi-plane Innova 2121 or 3131 Bi-plane System Innova X100 Monoplane Innova X100 Monoplane from product name Innova 2100, 3100 and 4100 Innova X100 Monoplane Innova 2100, 3100 and 4100
- Component
- Positioner Gantry Positioner Gantry Positioner Gantry
- Area
- X-ray Vascular
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray Vascular issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray Vascular issues
- The Worklist does not refresh on the system when performing a query.
- Innova System boot failure
- INX1X; Message Limit switch engaged; LP4 Lateral Detector lift will not move after going to max SID using the Emergency Backout button on the lift cover because the lift hit maximum (Max) SID limit sw…
- Firewall is broadcasting DHCP addresses
- Cooling Failure; Shut System down and call Service is displayed on the Innova Image monitor
- No gantry motion is reported by the customer.