PDU Emergency Stop Circuit Trips When Gradient Control Power Circuit Breaker is Turned On at PDU due to Incoming 480 Vol…
PDU Emergency Stop Circuit Trips When Gradient Control Power Circuit Breaker is Turned On at PDU due to Incoming 480 Volt Power to PDU Phase Reversed.
Symptom
PDU Emergency Stop Circuit Trips When Gradient Control Power Circuit Breaker is Turned On at PDU See Long Description The Teal PDU's emergency stop circuit trips when the Gradient Control power circuit breaker is turned on at the PDU, and it can't be reset as long as the Gradient Control CB is engaged. This happens even if the external emergency stop circuit is bypassed by placing the jumper plug on the PDU Control Board's J2 connection. This is an HFO3 to HFO5 upgrade. The computer was not yet booted so no error messages were logged.
Applies to
- Product
- Open Speed with EXCITE For HFO4 and HFO5 only
- Software
- OPENMR5-HFO5 Open Speed with Excite Product
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.