GE Healthcare · MR
Magnet Monitor devices Alarming for Coldhead Temperatures because the Checkout was not completed properly.hfo_orgi2 alar…
Magnet Monitor devices Alarming for Coldhead Temperatures because the Checkout was not completed properly.hfo_orgi2 alarm I2 - ShieldTemp Low.Magnet Monitor Devices Alarming For Coldhead Temperatures…
Symptom
hfo_orgi2 alarm I2 - ShieldTemp Low. The coldhead shield temperature is lower than the setting for the low alarm limit setting on the Magnet Monitor 3.
Error message
hfo_orgi2 alarm I2 - ShieldTemp Low. The coldhead shield temperature is lower than the setting for the low alarm limit setting on the Magnet Monitor 3.
Applies to
- Product
- Magnet Monitor 3. Magnet Monitor 3 Magnet Monitor 3
- Software
- Magnet Monitor 3 Revision 1.62 Magnet Monitor 3 Revision 1.62. Magmon3 Software has been updated to Revision 1.62 to support new magnet model type LCC-RB 1.5T. See Attached Service Note DOC0689332 and Long Description for more details. This software revision is also compatible with all installed base GE magnets (S2 through S5, SX, CX, LCC, LCC300 & 7.0T). The part number and revision of Magmon3 (P/N 2394952) is not changing. Refer to the latest version of Service Note DOC0689332 at http://3.87.118.28/optec3/common/fmisn/sn.htm
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.
- Fails to Scan with TORSO Coil.
- The Carriage Fails to Advance to Latch to the Table and to Retract When it is Raised, Undocked or Lowered.