GE Healthcare · MRExcite22445772248267224829311212841172254012

Unable to Scan with Gradient Errors Due to 5 Volt MGD Power Supply.

Symptom

Unable to Download or Reset the TPS MGD or ISE Unable to download TPS or ISE or MGD chassis

Error message

2244577 The GP reported a % Axis Current Distortion Fault 2244577 "The GP reported a Z Axis Current Distortion Fault. If no other faults occurred, check LCoil Calibration. Else, run Gradient Driver Tests to isolate the FRU. If Tests pass, see Troubleshooting Manual."

2248267 The RHO_DDS freq was set to 0 Hz. This value is too small. 2248267 11X, E2, G3,OPENMR4,5 error code is changing to 2248293 Post 11.1, E2M4a, G3M4b, OPENMR4, 5 sw 1121284117 6 1 Wed Jul 13 19:48:37 2005 2248267 4 lx-mr NSP SCP:cex_set_center_freq 1207 The RHO_DDS freq was set to 0 Hz. This value is too small. RHO_DDS will be set back to its default value. Probably a software error.

2254012 RRF-DIF Fiber Optic Link Error on the Master RRF-DIF board. Rx Signal Detect signal is in an Invalid State. Tue May 14 19:20:37 2002 2254012 1 bay12b_oc0 NSP SCP:RRF-DIF 630 RRF-DIF Fiber Optic Link Error on the Master RRF-DIF board. Rx Signal Detect signal is in an Invalid State.

Applies to

Models
Excite
Product
Excite Includes Excite 1 and Excite 2, 10.0, 11.0 and 11.1 Software.
Software
11.1 For product 1.5T Excite only. Note, 3T Excite goes with software G3, not 11.0 or 11.1.
Component
2292267 MGD RF Chassis 5 Volt Power Supply in front of MGD ----RF chassis -------
Area
MR

Full cause & step-by-step resolution

The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.

Start free trialSign in

7-day free trial · no credit card required

Related GE Healthcare MR issues