GE Healthcare · X-ray R&FAdvantx
Error 4271 during prep
Symptom
Error 4271 during prep
Error message
4271 Last exposure may be bad. Proceed with caution call service. See long description for error definition. AEC offset greater than 1.5 volts. The offset on the brightness signal is greater than 1.5 volts. The offset added to the AEC RAMP will be clamped at 1.5 volts and will probably cause AEC exposures to terminate early
Applies to
- Models
- Advantx
- Product
- Advantx-E Legacy
- Component
- RTBUS terminator 46-232712G1
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh