GE Healthcare · X-ray R&FAdvantx
Error 4272 when trying to take any AEC exposure
Symptom
Error 4272 when trying to take any AEC exposure When trying to make exposures on the table, wallstand, or even digital record exposures, the exposure would terminate immediately with error code 4272.
Error message
4272 Minimum exposure time attempted. Select new Technique to continue. Calulated AEC exposure time is negative or less than zero.
Applies to
- Models
- Advantx
- Product
- Advantx-E Legacy
- Component
- RTBUS terminator 46-232712G1
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- ADXE RFX/SFX Legacy popping noises during angulation SN 3715
- Advantx Rad Compax 40E system with SG100 Tilting Vertical Bucky Stand.
- Advantx Legacy system with DRS 3.2 with DRS Gateway.
- Digital Rad Error 6D00 on Advantx-E console.
- Advantx Erratic shutter operation Adjust motor and gear for proper mesh