GE Healthcare · MRExcite2248602

HDE System Emergency Stop EMO Trips Immediately after Reset.

Symptom

HDE System Emergency Stop EMO Trips Immediately after Reset When the EMO RESET is pressed, you can hear the contactor "connected or closing" sound in PDU, but it will disconnect immediately by itself. The main breaker was not tripped. The EMO Reset will not stay latched. Also a message; PDU is in stop mode,24V power is only 20.3V in the cabinet monitor appeared in the status window located in the upper left corner window. When the EMO RESET is pressed, you can hear the contactor "connected or closing" sound in PDU, but it will disconnect immediately by itself. The main breaker was not tripped. The EMO Reset will not stay latched. Also a message; PDU is in stop mode,24V power is only 20.3V in the cabinet monitor appeared in the status window located in the upper left corner window.

Error message

PDU is in stop mode, 24V power is only 20.3V in the cabinet monitor Appeared in the status window located in the upper left corner window.

2248602 PDU in Stop Mode. Emergency Stop button was pressed or PDU 24 Volt supply has failed. 2248602 PDU is in Stop mode. Emergency Stop button was pressed or PDU 24 Volt supply has failed.

Applies to

Models
Excite
Product
Excite HDe. For Hino HDe 14.0 and HDe 15.0 Software Systems only
Software
HDe 15.0 For Hino Excite HDe 15.0 systems only.
Component
5141286 Cabinet Monitor for Value 1.5T
Area
MR

Full cause & step-by-step resolution

The complete cause analysis, the step-by-step remedy and the attached service documents for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.

Start free trialSign in

7-day free trial · no credit card required

Related GE Healthcare MR issues