The Tomo will test / verify sweep but will not start sweep or exp during actual exposure request
Symptom
Install Ribbon Cable between System I/F Board and Tomolink I/F Board See Long Description Install the ribbon cable between the TomoLink I/F Board and the System I/F Board. Tomo-Link Upgrade Assy for Proteus XR/a System Dir 2289569-100 Rev0 on the schematic on page 3-1, and in the Proteus SM Dir 2273022-100 Rev17 schematic on page 10-21. It does show that a 25 pin cable (P/N: 221-2734) does/should exist between the TomoLink I/F Board on connector P2 and the System I/F Board on connector J115.
The Tomo will test / verify sweep but will not start sweep or exp during actual exposure request The Tomo will test/verify sweep but will not start sweep or exp during actual exposure request
Applies to
- Product
- PROTEUS XRa
- Component
- Tomolink
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- New Proteus Install.
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.