GE Healthcare · X-ray R&F2145656227302227224
New Proteus Install.
Symptom
New Proteus Install. Installers left a cable unconnected. Does not have a MIS number on it. Label shows it connects to J44 and the other end shows it connects to J45. Cable part number is 2145656-2. Proteus service manual 2273022-100 Schematic SG120 sheet 1 of 3 shows J45 connects to SG120 control board but does not show where J44 connects to. SG120 schematic sheet 1 of 3 shows MIS number is 27224 for cable 2145656-2
Applies to
- Product
- PROTEUS XRa
- Component
- SG120 Vertical Bucky Stand SG120 Vertical Bucky Stand
- Area
- X-ray R&F
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray R&F issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray R&F issues
- The Tomo will test / verify sweep but will not start sweep or exp during actual exposure request
- ADx-E Advantx-E console displayed a 6C00 Error (Digital Imaging Subsystem error - Error status received in IDC Prep Reply) when the first exposure of detector bad pixel calibration was attempted; cali…
- AEC Backup Time message
- New style ion chamber does not have a preamp
- Precision 500D Table Fluoro Carriage Front Bumper is not properly adjusted, allows excessive travel toward the front of the table.
- Precision 500D Aurora, dose readout does not update when an overhead Rad Tube Exposure is made, at any technic due to abnormally low mR/mAS from the Rad Overhead XRT.