Table longitudinal drive does not drive in and out smoothly.
Symptom
Table longitudinal drive does not drive in and out smoothly. It will drive in or out a short distance, then stops See Long Description Table longitudinal drive does not drive in and out smoothly. It will drive in or out a short distance, then stop, and tech must release and hit the button again to get it moving. This happens with or without coils connected. But if the tech hits the Home button there is no delay at all, it goes right Home without stopping. There are no errors logged. Note that this is not related at all to the table drive workflow changes coming with HF03 M4+SP2 software as that FMI (FMI 67706) hasn't been installed on this system yet (and that FMI will not fix this problem). This is a system problem.
Applies to
- Product
- HF OpenSpeed HFO1 HFO2 and HFO3 Only.
- Software
- HFO3
- Component
- 46-282361P3 Swing Table Longitudinal Encoder 46-282361P3 Swing Table Longitudinal Encoder
- Area
- MR
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare MR issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare MR issues
- Details of the OpenSpeed and Ovation Pinch Point Hazard Customer Letter Dated March 22, 2009 and Oct 29, 2008 respectively.
- Table Longitudinal Drive (In/Out) Behavior Not as Expected Following Installation of FMI 67704, 67706 or 67624.
- Running grafidy3, and find there are spikes on the waveforms in the manual prescan display, both windows.
- OrthoMRI Network cable is unplugged
- TPS/MGD fails to download or reset. mgd_term windows fail to mount file system.
- CWA ID100060 Unable To Film.