GE Healthcare · X-ray VascularAdvantxInnova
Unable to move LP gantry from parking to iso
Symptom
Unable to move either LP gantry from parking to iso or lateral SOD Unable to move LP gantry from parking to iso using standard parking/iso commands from TSSC. The SOD motion is not working too using commands from TSSC. Workaround to get either motion : perform an enable on Smart Handle, then initiate the parking / iso or SOD command on TSSC.
Applies to
- Models
- Advantx, Innova
- Product
- Advantx E Biplane Advantx E biplane systems: LCLP+ (22 cm II), LCN+ (32 cm II), LCALP+ (40 cm frontal plane, 32 cm lateral plane) Advantx E biplane systems: LCLP+ (22 cm II), LCN+ (32 cm II), LCALP+ (40 cm frontal plane, 32 cm lateral plane)
- Area
- X-ray Vascular
Full cause & step-by-step resolution
The complete cause analysis, the step-by-step remedy for this GE Healthcare X-ray Vascular issue are available to FSELIB subscribers — re-authored, web-first, searchable.
7-day free trial · no credit card required
Related GE Healthcare X-ray Vascular issues
- The Worklist does not refresh on the system when performing a query.
- Innova System boot failure
- INX1X; Message Limit switch engaged; LP4 Lateral Detector lift will not move after going to max SID using the Emergency Backout button on the lift cover because the lift hit maximum (Max) SID limit sw…
- Firewall is broadcasting DHCP addresses
- Cooling Failure; Shut System down and call Service is displayed on the Innova Image monitor
- No gantry motion is reported by the customer.